Led Strip Light Controller

Led Strip Light Controller

Product Name:ZIGBEE RGBW Strip Controller Model No.:GL-C-007 Voltage: DC12V-24V Output: Max. 6A/Channel, Total output Max.15A Size: 89*48*23.5mm Operating Temperature:-20-60° Thanks for buying our products. In this manual we will explain the connection of wires and the connection with a ZigBee...

Product Details


specification.jpg 

Product Name:ZIGBEE RGBW Strip Controller

Model No.:GL-C-007

Voltage: DC12V-24V

Output: Max. 6A/Channel, Total output Max.15A

Size: 89*48*23.5mm

Operating Temperature:-20-60°led strip light controllerled strip light controllerled strip light controllerled strip light controllerled strip light controllerled strip light controllerled strip light controllerled strip light controllerled strip light controller

Thanks for buying our products.

In this manual we will explain the connection of wires and the connection with a ZigBee Light

Link Gateway.

These devices works with many ZigBee Light Link Gateways* like Philips Hue, OsramLightify**

or IKEA Tradfri***.

Wire Connection:

1. Please prepare the cable like picture P1 and strip the isolation to 9-10 mm. The cable

cross-section must be between 0,33 and 2,08mm²(AWG22-14).

2. Now push down the terminal with a screwdriver and put in the cable, see picture P2.

3. Take the screwdriver away and the cable is connected with the terminal.

On picture P3-P7 you can see examples for the connection of different LED controllers:

- P3 for RGBW/RGBWW products

- P4 for RGB products, use a RGBW controller and don’t connect the wire W

- P5 for single color LED product, use a RGBW controller and don’t connect the wire

R, G, B

- P6 for RGB+CCT(warmwhite+coldwhite) products

- P7 for CCT(warmwhite+coldwhite) products

Connection with Gateway:

1. Connect the LED product to the controller see section “wire connection”.

2. Start the device searching on the ZigBee Light Link Gateway, it could take some time.

If the Gateway does not find the device, plug power off/on or make a reset.

3. The Gateway found your device and you can assign it to the different rooms/zones/groups.

4. Now you can use the device.

Reset:

1. Switch on your device.

2. Now switch off and on within 2 seconds.

3. Repeat off/on four times.

4. Reset is done when the device is switched on in the fifth time and the light stays on

after blinking 4 times.

led strip light controller

*For RGBW/RGBWW devices you will find two SSIDs. One for white/warmwhite, the other

for RGB.

**The Osram Gateway supports only one SSID, with the RGBW/RGBWW device it find onlyRGB.

***IKEA Gateway will support RGB devices till the end of the year 2017.

led strip light controller

Hot Tags: led strip light controller, China, manufacturers, suppliers, factory, made in China

Inquiry

You Might Also Like